| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
ipv6: fix possible infinite loop in rt6_fill_node()
Sashiko reported this issue [1]. Apply the same fix as
commit f8d8ce1b515a ("ipv6: fix possible infinite loop in fib6_info_uses_dev()").
Writers holding tb6_lock can list_del_rcu(&rt->fib6_siblings)
without waiting for RCU readers; rt->fib6_siblings.next then still
points into the old ring and this softirq-side walker never reaches
&rt->fib6_siblings, causing a CPU stall. fib6_del_route() always
WRITE_ONCE()s rt->fib6_nsiblings to 0 before list_del_rcu(), so an
inside-loop check is a reliable detach signal.
[1] https://sashiko.dev/#/patchset/20260526020227.4857-1-jiayuan.chen%40linux.dev |
| In the Linux kernel, the following vulnerability has been resolved:
net/sched: Fix ethx:ingress -> ethy:egress -> ethx:ingress mirred loop
When mirred redirects to ingress (from either ingress or egress) the loop
state from sched_mirred_dev array dev is lost because of 1) the packet
deferral into the backlog and 2) the fact the sched_mirred_dev array is
cleared. In such cases, if there was a loop we won't discover it.
Here's a simple test to reproduce:
ip a add dev port0 10.10.10.11/24
tc qdisc add dev port0 clsact
tc filter add dev port0 egress protocol ip \
prio 10 matchall action mirred ingress redirect dev port1
tc qdisc add dev port1 clsact
tc filter add dev port1 ingress protocol ip \
prio 10 matchall action mirred egress redirect dev port0
ping -c 1 -W0.01 10.10.10.10 |
| In the Linux kernel, the following vulnerability has been resolved:
tty: serial: samsung: Remove redundant port lock acquisition in rx helpers
Sashiko identified a deadlock when the console flow is engaged [1].
When console flow control is enabled (UPF_CONS_FLOW),
s3c24xx_serial_stop_tx() calls s3c24xx_serial_rx_enable() and
s3c24xx_serial_start_tx() calls s3c24xx_serial_rx_disable().
The serial core framework invokes the .stop_tx() and .start_tx()
callbacks with the port->lock spinlock already held. Furthermore, all
internal driver paths that invoke stop_tx (such as the DMA TX
completion handler s3c24xx_serial_tx_dma_complete() or the PIO TX IRQ
handler s3c24xx_serial_tx_irq()) also acquire port->lock prior to
calling it. (Note that s3c24xx_serial_start_tx() is only invoked by the
serial core).
However, s3c24xx_serial_rx_enable() and s3c24xx_serial_rx_disable()
unconditionally attempt to acquire port->lock again using
uart_port_lock_irqsave(). Since spinlocks are not recursive, this
causes a deadlock on the same CPU when console flow control is engaged.
Remove the redundant lock acquisition from both rx helper functions. |
| In the Linux kernel, the following vulnerability has been resolved:
bonding: prevent potential infinite loop in bond_header_parse()
bond_header_parse() can loop if a stack of two bonding devices is setup,
because skb->dev always points to the hierarchy top.
Add new "const struct net_device *dev" parameter to
(struct header_ops)->parse() method to make sure the recursion
is bounded, and that the final leaf parse method is called. |
| Loop with Unreachable Exit Condition ('Infinite Loop') vulnerability in Erlang OTP ssh (ssh_sftpd module) allows an authenticated SFTP user to render an SFTP channel permanently unresponsive.
The handle_data/4 function in ssh_sftpd contains a catch-all clause that accepts channel data of any type. When channel data with a non-zero type code (SSH_MSG_CHANNEL_EXTENDED_DATA) arrives with an empty pending buffer and a payload at or below the SFTP packet size limit, the clause tail-calls itself with identical arguments, creating an infinite loop.
The SFTP protocol operates exclusively on normal channel data (type 0). Extended data (non-zero type) is meaningless for SFTP and is never sent by conforming clients. However, the SSH protocol permits any channel participant to send extended data on an open channel, so an authenticated SFTP client can trigger the loop by sending SSH_MSG_CHANNEL_EXTENDED_DATA with any data_type_code and any non-empty payload at or below the size limit.
The targeted ssh_sftpd process enters an infinite tail-recursive loop. It never processes another message, its message queue grows without bound, and it can only be stopped by killing the process. BEAM's reduction-based scheduler preemption continues to function, so other processes on the node are not starved, but each stuck channel process consumes its full CPU time share continuously and accumulates unbounded message queue memory. Opening many channels amplifies the CPU and memory impact.
Erlang/OTP SSH configurations using the default max_channels setting (infinity) allow an authenticated user to open unlimited channels per connection, amplifying the attack without requiring multiple TCP connections or authentications.
No file contents, credentials, or write access are obtainable through this issue. The impact is limited to denial of service on targeted SFTP channels, with secondary CPU degradation and memory growth.
This vulnerability is associated with program file lib/ssh/src/ssh_sftpd.erl and program routine ssh_sftpd:handle_data/4.
This issue affects OTP from OTP 17.0 before OTP 29.0.3, OTP 28.5.0.3 and OTP 27.3.4.14, corresponding to ssh from 3.0.1 before 6.0.2, 5.5.2.2 and 5.2.11.9. |
| HTML::Bare versions through 0.04 for Perl will hang in an infinite loop when parsing malformed attributes.
The parserc_parse function never advances the attribute-parse state cursor on certain malformed attribute forms, looping forever.
Nameless attributes such as "<a ='c'>" or unbalanced quotes "<a b='''''''c'>" can trigger this condition.
Note that the latest version available on CPAN is version 0.02. Newer versions are available on the git repository. |
| XML::Bare versions through 0.53 for Perl will hang in an infinite loop when parsing malformed attributes.
The parserc_parse function never advances the attribute-parse state cursor on certain malformed attribute forms, looping forever.
Nameless attributes such as "<a ='c'>" or unbalanced quotes "<a b='''''''c'>" can trigger this condition. |
| Loop with unreachable exit condition ('infinite loop') in Active Directory Federation Services (AD FS) allows an unauthorized attacker to deny service over a network. |
| Loop with unreachable exit condition ('infinite loop') in Active Directory Federation Services (AD FS) allows an unauthorized attacker to deny service over a network. |
| Loop with unreachable exit condition ('infinite loop') in Azure Active Directory allows an unauthorized attacker to deny service over a network. |
| A denial of service vulnerability due to a deadlock was found in sctp_auto_asconf_init in net/sctp/socket.c in the Linux kernel’s SCTP subsystem. This flaw allows guests with local user privileges to trigger a deadlock and potentially crash the system. |
| In the Linux kernel, the following vulnerability has been resolved:
net/handshake: Use spin_lock_bh for hn_lock
nvmet_tcp_state_change(), a socket callback that runs in BH context,
can reach handshake_req_cancel() via nvmet_tcp_schedule_release_queue()
and tls_handshake_cancel(). handshake_req_cancel() acquires
hn->hn_lock with plain spin_lock(). If a process-context thread on
the same CPU holds hn->hn_lock when a softirq invokes the cancel path,
the lock attempt deadlocks. This is the only caller that invokes
tls_handshake_cancel() from BH context; every other consumer calls it
from process context.
Deferring the cancel to process context in the NVMe target is not
straightforward: nvmet_tcp_schedule_release_queue() must call
tls_handshake_cancel() atomically with its state transition to
DISCONNECTING. If the cancel were deferred, the handshake completion
callback could fire in the window before the cancel runs, observe the
unexpected state, and return without dropping its kref on the queue.
Reworking that interlock is considerably more invasive than hardening
the handshake lock. Convert all hn->hn_lock acquisitions from
spin_lock/spin_unlock to spin_lock_bh/spin_unlock_bh so the lock is
never taken with softirqs enabled. |
| protobufjs compiles protobuf definitions into JavaScript (JS) functions. Prior to 7.6.5 and 8.6.6, protobufjs parsed option names by advancing through schema tokens until reaching an = token without checking for end of input, so a crafted .proto schema that opens an option declaration and ends prematurely can cause parse, Root.load, or Root.loadSync to loop indefinitely. This issue is fixed in versions 7.6.5 and 8.6.6. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/gpusvm: Fix unbalanced unlock in drm_gpusvm_scan_mm()
There is a unbalanced lock/unlock to gpusvm notifier lock:
[ 931.045868] =====================================
[ 931.046509] WARNING: bad unlock balance detected!
[ 931.047149] 6.19.0-rc6+xe-**************** #9 Tainted: G U
[ 931.048150] -------------------------------------
[ 931.048790] kworker/u5:0/51 is trying to release lock (&gpusvm->notifier_lock) at:
[ 931.049801] [<ffffffffa090c0d8>] drm_gpusvm_scan_mm+0x188/0x460 [drm_gpusvm_helper]
[ 931.050802] but there are no more locks to release!
[ 931.051463]
The drm_gpusvm_notifier_unlock() sits under err_free label and the
first jump to err_free is just before calling the
drm_gpusvm_notifier_lock() causing unbalanced unlock. |
| OpenMcdf is a fully .NET / C# library to manipulate Compound File Binary File Format files, also known as Structured Storage. In 3.1.3 and earlier, the BST name-lookup loop in DirectoryTree.TryGetDirectoryEntry (OpenMcdf/DirectoryTree.cs:35-46) walks directory entries by repeatedly calling directories.TryGetSibling(child, siblingType, validateColor). A crafted CFB file with cyclic Left/Right sibling links among directory entries, constructed so the per-step BST-order check in TryGetSibling (DirectoryEntries.cs:84-85) is satisfied at every step, drives this while (child is not null) loop forever. There is no cycle detection in TryGetDirectoryEntry, and the bug is reachable from RootStorage.OpenStorage(name), TryOpenStorage(name), OpenStream(name), and TryOpenStream(name), causing an unrecoverable denial of service. This issue is fixed in version 3.1.4. |
| IBM Db2 11.5.0 through 11.5.9, and 12.1.0 through 12.1.4 is vulnerable to a trap when compiling a specially crafted statements containing subqueries could lead to a denial of service. |
| xrdp is an open source RDP server. In versions 0.10.6 and prior, a n issue was discovered where the software fails to properly validate the totalLength field within the RDP protocol control header during packet reception. An unauthenticated remote attacker can exploit this vulnerability by sending a specially crafted packet that forces the xrdp process or thread into an infinite, CPU-bound loop. Because the internal pointer fails to advance and the deadlock prevention mechanism is bypassed for specific protocol data unit types, the process consumes excessive CPU resources indefinitely. This can render the xrdp service unavailable and potentially lead to system-wide resource exhaustion if multiple malicious connections are established. This issue has been fixed in version 0.10.6.1. |
| In the Linux kernel, the following vulnerability has been resolved:
f2fs: fix missing read bio submission on large folio error
f2fs_read_data_large_folio() can keep a read bio across multiple
readahead folios. If a later folio hits an error before any of its
blocks are added to the bio, folio_in_bio is false and the current error
path returns immediately after ending that folio.
This can leave the bio accumulated for earlier folios unsubmitted. Those
folios then never receive read completion, and readers can wait
indefinitely on the locked folios.
Route errors through the common out path so any pending bio is submitted
before returning. Stop consuming more readahead folios once an error is
seen, and only wait on and clear the current folio when it was actually
added to the bio. |
| barebox version prior to 2026.04.0 contains a denial-of-service vulnerability in ext4 directory parsing in fs/ext4/ext4_common.c where the ext4fs_iterate_dir() function fails to validate that directory entry length values are non-zero. Attackers can supply a malicious ext4 filesystem image with a crafted directory entry containing a direntlen value of 0 to cause an infinite loop during directory listing or path resolution, resulting in the boot process hanging indefinitely. |
| Dasel is a command-line tool and library for querying, modifying, and transforming data structures. From 3.0.0 until 3.10.1, the selector lexer matchRegexPattern closure in (*Tokenizer).parseCurRune in selector/lexer/tokenize.go loops while tokenizing an unterminated regex literal such as r/ because peekRuneEqual returns false after the end of input, allowing attacker-controlled selector strings to consume CPU indefinitely. This issue is fixed in version 3.10.1. |
